|Grade, Semester||Year 1 1st semest [Department of Mechanical and Precision System, Faculty of Science and Engineering]|
|Category||Basic Major Subjects|
|Elective, Credits||Requisites 2credit|
You learn about the machine element which is the minimum unit which constitutes a machine.
The complicated machine has also combined the simple machine element in many cases.
Many of the machine elements are standardized and, in a design, the knowledge is needed.
I am required for a machine design, and about a typical machine element, I work and study structure, a standard, etc.
I learn the knowledge and skill about DP4 and DP5 in this lesson.
In order to design a machine, the knowledge about a machine element is required.
In a machine design, structure, a standard, graphics, etc. besides an outline are shown about an important machine element, and I consider it as the foundation of a machine design.
Perform a lecture and an exercise based on a textbook and ask for presentation by considering an exercise problem as a report at any time.
About the subject which asked for presentation during session, I certainly answer, and include the answers in the results.
The results of a term-end examination are mainly estimate.
They are 90% of a periodic exam, and 10% of a subject in a lesson.
I do a re-examination on the unsuccessful applicant(s) of a periodic exam in principle.
|Textbook||For beginner machine Element 3rd edition||Shinpo goichi||Riko-Gaku-Sha|
Before a lesson, please read the next lecture range of the specified textbook, and make collectively a note of the point which is hard to understand.
(About 1 hour)
After a lesson should carry out the review, when the subject in a lesson occurs, and please create the note of the contents.
When an understanding is not enough, please check and make a note of a point in question by next time.
Moreover, the first technical term to get to know should understand the meaning, and should summarize it in a note.
(About 2 hours)
We use a mathematical calculator.
|1||Meaning which studies a machine element |
|2||Engineering specification |
|5||Bolt and a nut|
|6||The machine element for combination 1 Washer Key|
|7||The machine element for combination 2|
|11||An axial joint|
|12||The machine element for movement transfer|